Drop Output On Input Loss

Drop IP/ASI output on input loss

MK.IO Beam can be configured to drop IP/ASI output on input loss. This can be configured for Live Encoder + Multiplexer feed templates.

To configure this, follow these steps:

• For the Live Encoder:

Go to the feed card then edit the Live Encoder by clicking next to the LIVE ENCODER component within the feed.

• Click the Output tab then click to edit the output.

• In the Common MPEG-2 TS Parameters section, set the Signal loss management to Drop transport stream.

• For the corresponding Multiplexer:

Go to the feed card then edit the Multiplexer by clicking next to the MULTIPLEXER component within the feed.

• From the Stream Processing tab, click Output stream > Service (x).

• Go to the Properties > Sources sub-tab then tick the Output Drop On Input TS Loss checkbox.