Troubleshooting on-boarding of edge devices

Use these checks when an edge device cannot connect to MK.IO or complete registration.

Prerequisites

• All edge devices require a network interface configured as Control with an IP address.

• DNS addresses that can resolve external domain names such as https://api.mk.io/.

• To register and manage an edge device, it must be able to connect to https://api.mk.io/. This requires either:

A default gateway that can route to the internet, and any customer-managed firewall MUST allow egress TCP port 443 to https://api.mk.io/.

• Or, configuration to use an HTTP proxy that can reach https://api.mk.io/.

• The device must have connected at least once to https://app.mk.io/ before it can be registered.

Cannot add device

When manually adding a device via the MK.IO UI, you may see an error similar to:

1000.4500.1500.1300 - Device is not recognised. A device with this ID has never connected to MK.IO. Connect the device to MK.IO and try again.

Check that the device network settings are correctly configured. See Network Configuration.

Connected field shows No in the device web UI

Diagnose via the device’s local web UI:

• Open the device’s local web UI: http://<Control-IP-Address>.

• Go to Appliance > Fleet. After a few seconds, additional information appears.

• Click next to the Connected: No field to run diagnostics.

• Resolve the network problem or configuration issue, then try again.

Diagnose via the device’s local terminal:

• Log in to the device’s terminal.

• Run the control-wizard command.

• MK.IO API connectivity is tested and results display on screen.

• Press Q to quit.

Short code not accepted

Short codes are short-lived. You can also use the Device ID.